Assemble kits in seconds. No tools are required. All components should be assembled by hand. Make sure your pots are clean before beginning assembly.

1. Turn WING NUT about 1½” – 2” down rod.
2. Place 1ST FLANGE on top of wing nut.
3. Rest POT on 1st flange leaving about 1” of rod.
4. Place 2nd FLANGE on pot.
5. Screw on EYE NUT until it loosely contacts 2nd flange. Make sure SAFETY HOLE is visible. If needed, adjust nuts up or down.
6. Slide flanges and position rod so that kit is centered in pot.
Tighten eye nut firmly by hand (about one-half turn).